HEATSHIELD HIGH PERFORMANCE MAT WITH ADHESIVE 450MM X 450MM x 1MM

Keep your cool with our Heatshield Products Heatshield Mat.

When used in applications with 1-inch of airspace and good airflow, this heat resistant material is capable of reflecting 90 percent of radiant heat. Face the aluminized side toward the source of radiant heat to shield heat away. This product withstands 1,100 degrees F of radiant heat (requires minimum of 1 inch of airspace) and up to 450 degrees F of direct heat, perfect for using underneath your floorpan to shield heat from your DPF, muffler, catalytic converter and exhaust system, or it can be used on the firewall to shield engine heat. It can also be used as a cold-air intake heatshield. Put it on your metal or plastic airbox to stop heat from raising air intake temperatures. The fire resistant mat is available with a high-temperature peel-and-stick adhesive. The self-adhesive version is not recommended for rough, unfinished fiberglass or carbon fiber. Bulk heatshield cloth rolls are available.

Features:

Continuous operating reflective temperature of 1100°F, 2000°F intermittent

Capable of reducing up to 90% of radiant heat

Adhesive backing sticks to almost any clean surface-not recommended for rough/unfinished fiberglass

Helps shield fire walls, hoods, body panels, floor boards

We strongly recommend rubbing any plastic intakes or air boxes 2 times with isopropyl alcohol after they have been cleaned before applying product

Heatshield Mat Installation tips:

Be sure to use a 1″ air-gap between HP Heatshield Mat and heat source for best results

HP Heatshield Mat is intended to be applied on the cold side of panel or component, i.e. it is not intended to direct contact with heat source

PRO TIP – Use poster board or butcher paper to make a template. For surfaces with severe bends, it may be necessary to cut relief lines or wedges to get product to conform. Transfer template to HP Heatshield Mat and cut.