These arbors are designed to adapt conventional machines eg. drill presses lathes milling machines and others to accept Holemaker annular cutters. This becomes a very economical alternative to normal methods of drilling or boring large diameter or deep holes. By adding an extension arbor and long series annular cutter to your industrial arbor you can achieve depths of up to 320mm in hollow section steel. Time savings in excess of 40% over normal drilling methods are not unusual. Specifications Morse Taper: #4 MT Maximum Depth of Cut: 50mm To Suit Shank Size: 3/4



Champion 3.2mm x 40mm Steel Split (Cotter) Pin - 200pk
Ehoma General Duty C-Clamp 150mm x 75mm 1000kgp
Teng 1/4in Dr. Ratchet Handle 72T
Teng 11in Long Reach Pliers - 45Deg. Bent
HAIDA SNAP-ON LENS CAP 77MM
Champion Retainer Spring To Suit 17/32in Shaft -50pk
Champion E-Clip Suit 1/8 Shaft -50pk
Tactix Combination Spanner 2-1/8in
Champion Retainer Spring To Suit 7/32in Shaft -50pk
Teng 10pc 5.5mm Drill Bit (DIN338)
Champion E-Clip Suit 5/8 Shaft -10pk
HEATSHIELD LAVA TURBO COVER FOR TURBOCHARGER T3
SANTINT V100 DC MOTOR 110V210RPM
Tactix Combination Spanner 1-5/8in
Teng 8pc TX Set With Ball Point End (Folding)
Teng Mini Bits 72T Ratchet w/ 8mm Ring Spanner
Teng 10pc 4.2mm Drill Bit (Din338) 